Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSSEAT BELT SYSTEMSTESTING AND INSPECTIONPINOUT VALUES AND DIAGNOSTIC PARAMETERS
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)
Pinout Values and Diagnostic Parameters
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Pinout Values and Diagnostic Parameters
SEAT BELT: SEAT BELT WARNING SYSTEM: TERMINALS OF ECU
TERMINALS OF ECU
1. CHECK COMBINATION METER ASSEMBLY
(a) Disconnect the E19 meter connector.
(b) Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
2. CHECK HEATER CONTROL PANEL (for Automatic Air Conditioning System)
(a) Disconnect the E23 panel connector.
(b) Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
3. CHECK CLOCK ASSEMBLY (for Manual Air Conditioning System)
(a) Disconnect the E22 clock connector.
(b) Measure the voltage and resistance of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.