Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONTHROTTLE BODYSERVICE AND REPAIRINSTALLATION
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)
Installation
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Installation
2GR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: INSTALLATION
INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new gasket to the intake air surge tank.
(b) Install the throttle body and wire harness clamp stay to the intake air surge tank with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the control motor connector.
(d) Connect the 2 water by-pass hoses to the throttle body.
2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. ADD ENGINE COOLANT Service and Repair
5. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
6. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.