Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVARIABLE VALVE TIMING ACTUATOR POSITION SENSORSERVICE AND REPAIRINSTALLATION
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)
Installation
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Installation
2GR-FE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION
INSTALLATION
1. INSTALL VVT SENSOR
(a) Install the 4 sensors with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the 4 sensor connectors.
2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation
3. INSTALL ENGINE ASSEMBLY
(a) Install the engine Installation.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.