SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRREMOVAL
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)

Removal

2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Removal







2GR-FE ENGINE CONTROL SYSTEM: ECM: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE AIR CLEANER CAP Removal

3. REMOVE AIR CLEANER CASE Removal

4. REMOVE ECM






(a) Remove the 3 bolts of the ECM bracket.






(b) Disconnect the 2 ECM connectors.
NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.
(1) Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
(c) Remove the ECM with bracket.






(d) Remove the 4 screws and 2 ECM brackets.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.