Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONPROGRAMMING AND RELEARNING
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)
Programming and Relearning
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Programming and Relearning
CRUISE CONTROL: CRUISE CONTROL SYSTEM: REGISTRATION
REGISTRATION
1. PERFORM VEHICLE STABILITY CONTROL SYSTEM RECOGNITION IN ECM
NOTE: If the vehicle has both cruise control and VSC, when replacing ECM, perform VSC recognition as follows:
(a) Turn the ignition switch ON.
(b) After waiting approximately 5 seconds, turn the cruise control main switch ON.
(c) Keep the cruise control main switch ON for approximately 5 seconds or more.
HINT: The VSC recognition will not be reflected in the cruise control system until the ignition switch is turned OFF and ON.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.