Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 4WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERSERVICE AND REPAIRREMOVAL
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)
Removal
2008 Toyota RAV4 4WD V6-3.5L (2GR-FE)SECTION Removal
DOOR LOCK: DOOR CONTROL TRANSMITTER MODULE: REMOVAL
REMOVAL
1. REMOVE TRANSMITTER HOUSING COVER
NOTE: Take extra care when handling these precision electronic components.
(a) Twist the screwdriver in the direction of the arrow mark in the illustration, and open the transmitter housing cover.
NOTE: Do not forcibly pry the cover.
HINT: Tape the screwdriver tip before use.
2. REMOVE DOOR CONTROL TRANSMITTER MODULE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.