Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008HIGHLANDER 2WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISSPECIFICATIONSCAPACITY SPECIFICATIONSREFRIGERANT OIL
2008 Toyota Highlander 2WD V6-3.5L (2GR-FE)
Refrigerant Oil
2008 Toyota Highlander 2WD V6-3.5L (2GR-FE)SECTION Refrigerant Oil
Standard (w/o Rear Air Conditioning System):
(Oil capacity inside the new compressor and magnetic clutch: 130 + 15 cc (4.4 + 0.51 fl.oz.) ) - (Remaining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be removed from the new compressor when replacing)
Standard (w/ Rear Air Conditioning System):
(Oil capacity inside the new compressor and magnetic clutch: 225 + 15 cc (7.6 + 0.51 fl.oz.) ) - (Remaining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be removed from the new compressor when replacing)
(Oil capacity inside the new compressor and magnetic clutch: 130 + 15 cc (4.4 + 0.51 fl.oz.) ) - (Remaining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be removed from the new compressor when replacing)
Standard (w/ Rear Air Conditioning System):
(Oil capacity inside the new compressor and magnetic clutch: 225 + 15 cc (7.6 + 0.51 fl.oz.) ) - (Remaining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be removed from the new compressor when replacing)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.