Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008HIGHLANDER 2WD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESCURSOR OR MAP ROTATES WHEN VEHICLE STOPPED
2008 Toyota Highlander 2WD V6-3.5L (2GR-FE)
Cursor or MAP Rotates When Vehicle Stopped
2008 Toyota Highlander 2WD V6-3.5L (2GR-FE)SECTION Cursor or MAP Rotates When Vehicle Stopped
NAVIGATION: NAVIGATION SYSTEM: Cursor or Map Rotates when Vehicle Stopped
Cursor or Map Rotates when Vehicle Stopped
INSPECTION PROCEDURE
PROCEDURE
1. CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK:
Vehicle has not been turned by turntable.
HINT: If the vehicle is turned on a turntable with the ignition switch on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate.
NG -- TURN IGNITION SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.