Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008CAMRY XLE, 2.4 EREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSPREPARATION - EXCEPT HYBRIDBRAKE CONTROLSST
2008 Toyota Camry XLE, 2.4 E
Brake Control: SST
2008 Toyota Camry XLE, 2.4 ESECTION SST
REFERENCE CHART FOR SST
| 09023-00101 | Union Nut Wrench 10 mm | ||
| 09023-38200 | Union Nut Wrench 12 mm | ||
| 09213-58013 | Crankshaft Pulley Holding Tool | ||
| 09309-36010 | Transmission Rear Bearing Replacer | ||
| 09520-00031 | Rear Axle Shaft Puller | ||
| (09520-00040) | Shocker | ||
| (09521-00010) | Rod with Grip | ||
| 09521-00020 | Drive Shaft Boot Clamping Tool | ||
| 09950-00020 | Bearing Remover |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.