Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20084 RUNNER 2WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRREAR NO. 1 SEAT ASSEMBLYINSTALLATION
2008 Toyota 4 Runner 2WD V8-4.7L (2UZ-FE)
Installation
2008 Toyota 4 Runner 2WD V8-4.7L (2UZ-FE)SECTION Installation
SEAT: REAR NO. 1 SEAT ASSEMBLY: INSTALLATION
SEAT: REAR NO. 1 SEAT ASSEMBLY: INSTALLATION
1. INSTALL REAR SEATBACK ASSEMBLY LH
(a) Install the seatback with the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
2. INSTALL REAR SEATBACK ASSEMBLY RH
(a) Install the seatback with the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
(b) Install the floor anchor with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
3. INSTALL REAR SEAT CUSHION ASSEMBLY LH
(a) Install the cushion with the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
(b) Install the 2 hinge covers.
4. INSTALL REAR SEAT CUSHION ASSEMBLY RH
HINT: Use the same procedures described for the LH side.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.