SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20084 RUNNER 2WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTENTERTAINMENT SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSTELEVISION DISPLAY POWER SOURCE CIRCUIT
2008 Toyota 4 Runner 2WD V8-4.7L (2UZ-FE)

Television Display Power Source Circuit

2008 Toyota 4 Runner 2WD V8-4.7L (2UZ-FE)SECTION Television Display Power Source Circuit








AUDIO / VISUAL: REAR SEAT ENTERTAINMENT SYSTEM: Television Display Power Source Circuit

Television Display Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the television display assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT TELEVISION DISPLAY ASSEMBLY
(a) Disconnect the connector from the television display assembly.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance





(c) Measure the voltage according to the value(s) in the table below.

Standard voltage





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.