Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER HYBRID, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (HYBRID)CRANKSHAFT POSITION SENSORINSTALLATION
2007 Toyota Highlander Hybrid, FWD
Crankshaft Position Sensor: Installation
2007 Toyota Highlander Hybrid, FWDSECTION Installation
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 8.0 N*m (80 kgf*cm, 71 in.*lbf)
- Connect the crankshaft position sensor connector.
- INSTALL FRONT FENDER APRON SEAL RH
- Install the front fender apron seal RH with the clip and 2 bolts.
- INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
- Install the front fender splash shield sub-assembly RH with the screw and clip.
- INSTALL ENGINE UNDER COVER NO.1 (See INSTALLATION )
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.