SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER HYBRID, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCAN COMMUNICATION SYSTEM (HYBRID)CAN COMMUNICATION SYSTEMHOW TO PROCEED WITH TROUBLESHOOTING
2007 Toyota Highlander Hybrid, FWD

How To Proceed With Troubleshooting

2007 Toyota Highlander Hybrid, FWDSECTION How To Proceed With Troubleshooting
NOTE:
  • Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.
  • DTCs U0110-159, U0110-160, U0110-656, and U0110-657 are not DTCs for the CAN communication system. Therefore, refer to the troubleshooting procedures for the hybrid control system.
  1. CHECK AND CLEAR DTCS 
  2. CHECK CAN BUS LINE 
    1. Check the CAN BUS LINE .
  3. CHECK INTELLIGENT TESTER VIA CAN VIM 
    1. Select "BUS CHECK" (See DIAGNOSIS SYSTEM ).

      Result 

      DTC RESULT DESCRIPTION

      A All the ECUs and sensors connected to the CAN communication system are displayed on the screen.
      B An ECU or sensor not connected to the CAN communication system is displayed on the screen.
      C More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the 'ENGINE' and 'HV', proceed to B)
      NOTE:
      • The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (See DIAGNOSIS SYSTEM ).
      • Non-installed ECUs or sensors are not displayed. Do not mistake them for being in the communication stop mode.
      • If 2 or more ECUs or sensors are not displayed on the intelligent tester via the CAN VIM, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN sub bus lines.)
      • If DTCs U0146-435 and P3108-594 are output and 'GATEWAY' is displayed in 'BUS CHECK' on the intelligent tester, refer to the MULTIPLEX COMMUNICATION SYSTEM .

    B: COMMUNICATION STOP MODE TABLE 

    C: GO TO   1 "CHECK FOR AN OPEN IN ONE SIDE OF THE CAN SUB BUS LINES" 

    A: Go to next step. 

  4. DTC COMBINATION TABLE 
    1. Confirm trouble according to the combination of output DTCs regarding the CAN communication system.

      HINT:

      Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester's "BUS CHECK" screen via CAN VIM.

  5. CIRCUIT INSPECTION 
  6. IDENTIFICATION OF PROBLEM 
  7. REPAIR OR REPLACE 
  8. CONFIRMATION TEST 

    NEXT: END 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.