Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORTESTING AND INSPECTION
2007 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
Crankshaft Position Sensor: Testing and Inspection
2007 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Testing and Inspection
INSPECTION
INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance between the terminals.
If the result is not as specified, replace the sensor.
INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance between the terminals.
If the result is not as specified, replace the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.