Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURES
2007 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
Symptom Related Diagnostic Procedures
2007 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Symptom Related Diagnostic Procedures
PROBLEM SYMPTOMS TABLE
If a normal system code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table and proceed to the relevant troubleshooting.
HINT: Inspect the fuse and relay before investigating the suspected areas shown in the table.
Inspect each malfunctioning circuit in numerical order for the corresponding symptom.
Problem Symptoms Table - Wireless Door Lock Control System (Part 1):
Problem Symptoms Table - Wireless Door Lock Control System (Part 2):
If a normal system code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table and proceed to the relevant troubleshooting.
HINT: Inspect the fuse and relay before investigating the suspected areas shown in the table.
Inspect each malfunctioning circuit in numerical order for the corresponding symptom.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.