Wiper Switch: Service and Repair

2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION Service and Repair
REMOVAL

1. REMOVE STEERING COLUMN COVER LOWER
2. REMOVE STEERING COLUMN COVER UPPER




3. REMOVE WIPER SWITCH
a. Disconnect the connector.
b. Disengage the claw and remove the wiper switch.

NOTE: If the claw is pushed with excessive force, it may be broken.


INSTALLATION

1. INSTALL WIPER SWITCH
a. Install the wiper switch with the claw.
b. Connect the connector.

2. INSTALL STEERING COLUMN COVER UPPER
3. INSTALL STEERING COLUMN COVER LOWER
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.