Wiper and Washer Systems: Service Precautions

2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION Service Precautions
PRECAUTION

1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

a. Do not clean or adjust the washer nozzle with a safety pin, etc. because;
1. the washer nozzle tip is made of resin and could be damaged.
2. adjustment is not necessary because the washer nozzle is spray type.

b. In case the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush, etc.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.