Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER 2WD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD, ENGINE
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)
Connecting Rod, Engine
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION Connecting Rod, Engine
Connecting rod
Maximum misalignment per 100 mm (3.94 in.) 0.05 mm (0.0020 in.) per 100 mm (3.94 in.)
Maximum rod twist per 100 mm (3.94 in.) 0.15 mm (0.0059 in.) per 100 mm (3.94 in.)
Bush inside diameter 22.005 to 22.014 mm (0.8663 to 0.8667 in.)
CONNECTION ROD CAP
Tighten the bolts in several steps by the specified torque.
Torque 25 Nm (255 kgf-cm, 18 ft. lbs.)
Mark the front side of each connecting cap bolt with paint.
Retighten the cap bolts by 90° as shown in the illustration.
Maximum misalignment per 100 mm (3.94 in.) 0.05 mm (0.0020 in.) per 100 mm (3.94 in.)
Maximum rod twist per 100 mm (3.94 in.) 0.15 mm (0.0059 in.) per 100 mm (3.94 in.)
Bush inside diameter 22.005 to 22.014 mm (0.8663 to 0.8667 in.)
CONNECTION ROD CAP
Tighten the bolts in several steps by the specified torque.
Torque 25 Nm (255 kgf-cm, 18 ft. lbs.)
Mark the front side of each connecting cap bolt with paint.
Retighten the cap bolts by 90° as shown in the illustration.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.