On-Vehicle Inspection

2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION On-Vehicle Inspection
ON-VEHICLE INSPECTION

CHECK CAMSHAFT TIMING OIL CONTROL VALVE (OCV) ASSEMBLY

a. Connect the intelligent tester or OBD II scan tool to the DLC3.
b. Turn the ignition switch ON.
c. Start the engine and warm it up.
d. Select the VVT from the ACTIVE TEST menu.




e. Check the engine speed when the OCV is operated by the intelligent tester or OBD II scan tool.

If the result is not as specified, replace the OCV assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.