Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER 2WD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONREADING AND CLEARING DIAGNOSTIC TROUBLE CODESCLEARING TROUBLE CODESWITHOUT SCAN TOOL
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)
Without Scan Tool
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION Without Scan Tool
CLEAR DTC (Without using an intelligent tester)
Perform either one of the following operations:
1. Disconnect the negative battery cable for more than 1 minute.
2. Remove the EFI No. 1 and ETCS fuses from the Relay Block (R/B) located inside the engine compartment for more than 1 minute.
Perform either one of the following operations:
1. Disconnect the negative battery cable for more than 1 minute.
2. Remove the EFI No. 1 and ETCS fuses from the Relay Block (R/B) located inside the engine compartment for more than 1 minute.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.