Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2007HIGHLANDER 2WD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSACIS CONTROL CIRCUIT
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)
ACIS Control Circuit
2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION ACIS Control Circuit
ACIS Control Circuit
DESCRIPTION
HINT: ACIS stands for "Acoustic Control Induction System".
The ECM opens and closes the Intake Air Control (IAC) valve No. 2 in response to engine speed (RPM/ NE). This system improves intake manifold tuning for better efficiency at low and high engine rpm. When the engine speed is 4,000 rpm or less and the throttle valve opening angle is 30° or more, the ECM turns the VSV ON to operate the IAC valve.
INSPECTION PROCEDURE
DESCRIPTION
HINT: ACIS stands for "Acoustic Control Induction System".
The ECM opens and closes the Intake Air Control (IAC) valve No. 2 in response to engine speed (RPM/ NE). This system improves intake manifold tuning for better efficiency at low and high engine rpm. When the engine speed is 4,000 rpm or less and the throttle valve opening angle is 30° or more, the ECM turns the VSV ON to operate the IAC valve.
Wiring Diagram:
Step 1:
Step 1(continued)-3:
Step 4-5:
Step 5(continued)-6:
INSPECTION PROCEDURE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.