Power Locks: Service Precautions

2007 Toyota Highlander 2WD V6-3.3L (3MZ-FE)SECTION Service Precautions
POWER DOOR LOCK CONTROL SYSTEM

PRECAUTION

1. NOTICES OF REMOVAL AND INSTALLATION OPERATIONS
a. Before performing operations related to the door lock and door lock cylinder, be sure to disconnect the battery terminal or the connector of the window regulator motor.

CAUTION: If the operation is performed with the connectors being connected, the door control switch inside the door lock might be unexpectedly actuated, which results in injury.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.