Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA20074RUNNER SPORT, 4.0 U, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEM (1GR-FE)VVT SENSORINSTALLATION

2007 Toyota 4Runner Sport, 4.0 U, RWD

VVT Sensor: Installation

2007 Toyota 4Runner Sport, 4.0 U, RWDSECTION Installation

INSTALL VVT SENSOR
1. LH bank side VVT sensor.
  1. Apply a light coat of engine oil to an O-ring of the VVT sensor.
  2. Install the VVT sensor with the bolt.
    Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
    
    Fig 1: Locating VVT Sensor Bolt
    Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  3. Connect the VVT sensor connector.
  4. Connect the water bypass hoses No. 4 and No. 5.
    
    Fig 2: Locating Water Bypass Hoses No. 4 And No. 5
    Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. RH bank side VVT sensor.
  1. Apply a light coat of engine oil to an O-ring of the VVT sensor.
  2. Install the VVT sensor with the bolt.
    Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
    
    Fig 3: Locating VVT Sensor Bolt
    Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  3. Connect the VVT sensor connector.
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
CONNECT VENTILATION HOSE NO.2
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKS (See REPLACEMENT )
INSTALL V-BANK COVER
1. Install the V-bank cover with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.