Quick Lookups: Fluids

2006 Toyota Tacoma Base, 4D Pickup, StandardSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 5.00 OZS. 0.14 L PAG 46 S
Air Cond Refrigerant 1.35 LBS. 0.61 KG R-134a S
Brake Fluid N/A N/A DOT 3 Brake Fluid S
Differential Gear Oil 4WD Front 1.60 QTS. 1.51 L API - GL-5, SAE 75W-90 Hypoid Gear Oil Without Limited-Slip Differential: Hypoid Gear Oil API - GL-5, with Limited-Slip Differential: Hypoid Gear Oil for Limited-Slip Differential API - GL-5. S
Differential Gear Oil 4WD Rear 3.00 QTS. 2.83 L API - GL-5, SAE 90W (Above 0Deg.F), SAE 80W or 80W-90 (Below 0Deg.F) Without Limited-Slip Differential: Hypoid Gear Oil API - GL-5, with Limited-Slip Differential: Hypoid Gear Oil for Limited-Slip Differential API - GL-5. S
Engine Coolant 4.0L Eng,Standard Trans 10.30 QTS. 9.74 L TOYOTA Super Long Life Coolant or equivalent DO NOT use alcohol type antifreeze or plain water alone. S
Engine Oil 4.0L Eng,4WD Drain and Refill,w/Filter 5.50 QTS. 5.2 L SAE 5W-30 S
Engine Oil 4.0L Eng,4WD Drain and Refill,w/o Filter 5.20 QTS. 4.92 L SAE 5W-30 S
Fuel Tank 21.10 GALS. 79.87 L S
Manual Transmission Fluid 4.0L Eng 1.90 QTS. 1.79 L API - GL-4 or GL-5, SAE 75W-90 S
Power Steering Fluid N/A N/A Automatic Transmission Fluid DEXRON II or DEXRON III S
Transfer Case Fluid 1.10 QTS. 1.04 L API - GL-4 or GL-5, SAE 75W-90 S
Windshield Washer Fluid N/A N/A Plain water In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.