Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006TACOMA BASE, 4D PICKUP, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEMIRRORSPREPARATION1GR-FE ENGINE MECHANICALSST
2006 Toyota Tacoma Base, 4D Pickup, Standard
1GR-FE Engine Mechanical: SST
2006 Toyota Tacoma Base, 4D Pickup, StandardSECTION SST
SST TABLE - 1GR-FE ENGINE MECHANICAL
| 09011-38121 | 12 mm Socket Wrench for 12 Pointed Head | |
| 09032-00100 | Oil Pan Seal Cutter | |
| 09201-01055 | Valve Guide Bushing Remover & Replacer 5.5 | |
| 09201-10000 | Valve Guide Bushing Remover & Replacer Set | |
| 09201-41020 | Valve Stem Oil Seal Replacer | |
| 09202-70020 | Valve Spring Compressor | |
| (09202-00010) | Attachment | |
| 09213-54015 | Crankshaft Pulley Holding Tool | |
| (91651-60855) | Bolt | |
| 09222-30010 | Connecting Rod Bushing Remover & Replacer | |
| 09223-78010 | Crankshaft Oil Seal Replacer | |
| 09226-10010 | Crankshaft Front & Rear Bearing Replacer | |
| 09330-00021 | Companion Flange Holding Tool | |
| 09550-60010 | Differential Side Bearing Replacer | |
| (09951-00350) | Replacer 35 | |
| 09843-18030 | Tacho-pulse Pickup Wire No.2 | |
| 09843-18040 | Diagnosis Check Wire No.2 | |
| 09950-50013 | Puller C Set | |
| (09951-05010) | Hanger 150 | |
| (09952-05010) | Slide Arm | |
| (09953-05020) | Center Bolt 150 | |
| (09954-05030) | Claw No.3 | |
| 09950-60010 | Replacer Set | |
| (09951-00250) | Replacer 25 | |
| 09950-70010 | Handle Set | |
| (09951-07100) | Handle 100 | |
| (09951-07150) | Handle 150 | |
| 09992-00500 | Compression Gauge Attachment |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.