DISARMING THE RS3200 PLUS (except PASSIVE DISARMING)

2006 Toyota Tacoma Base, 4D Pickup, StandardSECTION DISARMING THE RS3200 PLUS (except PASSIVE DISARMING)

The system may be DISARMED in several ways. Do one of the following:

Unlock the doors with your key:

Insert the key into the door key switch and turn it toward the rear of the vehicle:

The STATUS MONITOR'S led stops flashing.(1) The system is now DISARMED.*

G06743064Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002

Unlock the doors with the remote control:

Press the unlock button on the remote control. Simultaneously:

The driver's door unlocks.(2)

The vehicle's tail and marker or turn signal lights flash twice.(3)

The vehicle's buzzer chirps twice. Ξ”

The STATUS MONITOR'S LED stops flashing.(1) The system is now DISARMED.*

Press the unlock button again within 3 seconds after unlocking the driver's door to unlock the remaining doors.

G06743065Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002

Use the ignition switch:

Insert the key into the ignition switch, then turn it to ON.

The STATUS MONITOR'S LED stops flashing.(1) The system is now DISARMED.*

This method of disarming is rarely used. You must be inside the vehicle while the system is armed in order to do it.Β 

G06743066Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
NOTE: If your vehicle's tail and marker or turn signal lights turn on for 2 seconds when the system is DISARMED,* the TRIGGER MEMORY was activated; something TRIGGERED an Alarm while you were away from the vehicle.
G06743067Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
G06743068Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
G06743069Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002

* Please note, if the system utilizes your vehicle's engine immobilizer system LED instead of the STATUS MONITOR, the LED will continue to flash.

Ξ” If your vehicle is equipped with a buzzer.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.