Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006TACOMA BASE, 4D PICKUP, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSPREPARATIONVF2BM TRANSFERSST
2006 Toyota Tacoma Base, 4D Pickup, Standard
VF2BM Transfer: SST
2006 Toyota Tacoma Base, 4D Pickup, StandardSECTION SST
SST TABLE - VF2BM TRANSFER
| 09223-15020 | Oil Seal & Bearing Replacer | |
| 09223-46011 | Crankshaft Front Oil Seal Replacer | |
| 09308-00010 | Oil Seal Puller | |
| 09316-60011 | Transmission & Transfer Bearing Replacer | |
| (09316-00011) | Replacer Pipe | |
| (09316-00031) | Replacer B | |
| (09316-00071) | Replacer F | |
| 09330-00021 | Companion Flange Holding Tool | |
| 09515-30010 | Rear Wheel Bearing Replacer | |
| 09527-10011 | Rear Axle Shaft Bearing Remover | |
| 09554-22010 | Differential Oil Seal Replacer | |
| 09554-30011 | Differential Oil Seal Replacer | |
| 09555-55010 | Differential Drive Pinion Bearing Replacer | |
| 09612-65014 | Steering Worm Bearing Puller | |
| (09612-01030) | Claw C | |
| (09612-01050) | Hanger Pin with Nut | |
| 09631-32020 | Seal Ring Tool | |
| 09950-40011 | Puller B Set | |
| (09951-04020) | Hanger 200 | |
| (09952-04010) | Slide Arm | |
| (09953-04030) | Center Bolt 200 | |
| (09954-04010) | Arm 25 | |
| (09955-04051) | Claw No.5 | |
| (09957-04010) | Attachment | |
| (09958-04011) | Holder | |
| 09950-60010 | Replacer Set | |
| (09951-00320) | Replacer 32 | |
| (09951-00570) | Replacer 57 | |
| (09951-00580) | Replacer 58 | |
| (09951-00590) | Replacer 59 | |
| 09950-70010 | Handle Set | |
| (09951-07100) | Handle 100 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.