Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2006TACOMA BASE, 4D PICKUP, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTINGFOG LIGHT ASSEMBLYREMOVAL

2006 Toyota Tacoma Base, 4D Pickup, Standard

Fog Light Assembly: Removal

2006 Toyota Tacoma Base, 4D Pickup, StandardSECTION Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FOG LIGHT ASSEMBLY
1. Disconnect the connector.
2. Disengage the 2 claws and remove the fog light assembly LH.
  
  Fig 1: Removing Fog Light Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. To remove the fog light socket and bulb, turn them in the direction indicated by the arrow in Fig 2.
4. Remove the fog light bulb from the light socket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.