Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SIENNA FWD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSTAIL LAMPSERVICE AND REPAIRDISASSEMBLY AND REASSEMBLY
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)
Disassembly and Reassembly
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)SECTION Disassembly and Reassembly
DISASSEMBLY
1. REMOVE REAR COMBINATION LIGHT BULB
a. Turn in the direction indicated by the arrow and separate the 2 rear combination light bulbs.
b. Remove the 2 rear combination light bulbs from the rear combination light socket and wire subassembly.
REASSEMBLY
1. INSTALL REAR COMBINATION LIGHT BULB
a. Install the 2 rear combination light bulbs to the rear combination light socket and wire sub-assembly.
b. Turn in the direction indicated by the arrow and install the 2 rear combination light bulbs to the rear combination light assembly.
1. REMOVE REAR COMBINATION LIGHT BULB
a. Turn in the direction indicated by the arrow and separate the 2 rear combination light bulbs.
b. Remove the 2 rear combination light bulbs from the rear combination light socket and wire subassembly.
REASSEMBLY
1. INSTALL REAR COMBINATION LIGHT BULB
a. Install the 2 rear combination light bulbs to the rear combination light socket and wire sub-assembly.
b. Turn in the direction indicated by the arrow and install the 2 rear combination light bulbs to the rear combination light assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.