Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SIENNA FWD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTENTERTAINMENT SYSTEMSTELEVISION / MONITORSERVICE AND REPAIR
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)
Television / Monitor: Service and Repair
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)SECTION Service and Repair
TELEVISION DISPLAY
REMOVAL
1. REMOVE TELEVISION BASE
a. Release the 4 clips and remove the television base.
2. REMOVE TELEVISION DISPLAY ASSEMBLY
a. Disconnect the connector and remove the 4 bolts and the television display assembly.
INSTALLATION
1. INSTALL TELEVISION DISPLAY ASSEMBLY
a. Install the television display assembly with the 4 bolts.
b. Connect the connector.
2. INSTALL TELEVISION BASE
a. Engage the 4 clips to install the television base.
REMOVAL
1. REMOVE TELEVISION BASE
a. Release the 4 clips and remove the television base.
2. REMOVE TELEVISION DISPLAY ASSEMBLY
a. Disconnect the connector and remove the 4 bolts and the television display assembly.
INSTALLATION
1. INSTALL TELEVISION DISPLAY ASSEMBLY
a. Install the television display assembly with the 4 bolts.
b. Connect the connector.
2. INSTALL TELEVISION BASE
a. Engage the 4 clips to install the television base.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.