Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SIENNA FWD V6-3.3L (3MZ-FE)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONDIAGNOSTIC TROUBLE CODE DESCRIPTIONSTIRE PRESSURE WARNING SYSTEM
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)
Tire Pressure Warning System
2006 Toyota Sienna FWD V6-3.3L (3MZ-FE)SECTION Tire Pressure Warning System
DIAGNOSTIC TROUBLE CODE CHART
HINT:
^ If no abnormality is found when the parts are inspected, inspect the skid control ECU.
^ When a malfunction is found in the skid control ECU, replace the brake actuator assembly.
^ If a malfunction code is displayed during the DTC check, check the circuit listed for that code. For details of each code, refer to the DTC chart.
^ DTC 13 will not be output, if the check is performed by the intelligent tester.
HINT:
^ If no abnormality is found when the parts are inspected, inspect the skid control ECU.
^ When a malfunction is found in the skid control ECU, replace the brake actuator assembly.
^ If a malfunction code is displayed during the DTC check, check the circuit listed for that code. For details of each code, refer to the DTC chart.
^ DTC 13 will not be output, if the check is performed by the intelligent tester.
DTC 13-C2106/11:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.