Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWASHER FLUID LEVEL INDICATORTESTING AND INSPECTION
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Washer Fluid Level Indicator: Testing and Inspection
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Testing and Inspection
INSPECT WASHER LEVEL WARNING LIGHT OPERATION
a. Disconnect the connectors from the combination meter.
b. Connect the negative (-) lead from the battery to terminal 16.
c. Turn the ignition switch ON and check that the warning light comes on.
If the warning light does not come on, test the bulb.
a. Disconnect the connectors from the combination meter.
b. Connect the negative (-) lead from the battery to terminal 16.
c. Turn the ignition switch ON and check that the warning light comes on.
If the warning light does not come on, test the bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.