Back Door Power Window Motor Circuit

2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Back Door Power Window Motor Circuit
Back Door Power Window Motor Circuit

DESCRIPTION
The back door power window goes down when voltage is applied to the BDDN terminal of the back door ECU, and the window goes up when voltage is applied to the BDUP terminal.

Wiring Diagram:






Step 1-2:




Step 2(Continued)-3:




INSPECTION PROCEDURE

HINT: When using the intelligent tester, start the inspection from step 1 and when not using the intelligent tester, start from step 2.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.