Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSDESCRIPTION AND OPERATION
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Windows: Description and Operation
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Description and Operation
System Outline
The power window motor will operate when the power window SW, remote control SW, or the key-linked SW is operated.
1. Power Window SW Manual/Automatic Operation
When the ignition SW is turned ON, or during key-off operation stand-by mode, the power window can be operated by the power window SW.
2. Remote Control SW Manual/Automatic Operation
When the ignition SW is turned ON, or during key-off operation stand-by mode, the power window can be operated by the master SW. The front passenger, rear left, right windows can be operated according to the remote control signals from the driver door ECU.
3. Key-Off Operation
With all the doors closed, within 43 seconds after the ignition switch has been turned to OFF from ON, the power window can be operated. However, if the front door is opened, the power window cannot be operated.
4. Jam Protection Function
When load is detected, the power window motor is rotated to the opposite direction.
The driver's seat, front passenger seat and back door power windows have this function.
5. Back Door Key Operation SW
When the back door key SW is operated to LOCK or UNLOCK side for more than approximately 0.75 seconds, the back door window can be opened/closed manually.
The power window motor will operate when the power window SW, remote control SW, or the key-linked SW is operated.
1. Power Window SW Manual/Automatic Operation
When the ignition SW is turned ON, or during key-off operation stand-by mode, the power window can be operated by the power window SW.
2. Remote Control SW Manual/Automatic Operation
When the ignition SW is turned ON, or during key-off operation stand-by mode, the power window can be operated by the master SW. The front passenger, rear left, right windows can be operated according to the remote control signals from the driver door ECU.
3. Key-Off Operation
With all the doors closed, within 43 seconds after the ignition switch has been turned to OFF from ON, the power window can be operated. However, if the front door is opened, the power window cannot be operated.
4. Jam Protection Function
When load is detected, the power window motor is rotated to the opposite direction.
The driver's seat, front passenger seat and back door power windows have this function.
5. Back Door Key Operation SW
When the back door key SW is operated to LOCK or UNLOCK side for more than approximately 0.75 seconds, the back door window can be opened/closed manually.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.