Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSRECALL - REPLACEMENT OF FRONT LOWER BALL JOINTSVII. APPENDIX
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
VII. Appendix
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION VII. Appendix
VII. APPENDIX
PARTS KIT CONTENTS
REFERENCE FOR EARLY 2004 MODEL YEAR TUNDRA VEHICLES
^ Please note that all 2004 Model Year vehicles require Ball Joint Replacement either under SSC 70B or SSC 50J. However, you may encounter some early 2004 vehicles with either the 70B or 50J ball joint.
^ The following procedure will help you identify which campaign the early 2004 Model Year vehicle falls under.
1) Confirm the size of the "Front Suspension Lower Ball Joint Bolt Heads."
a) For vehicles with...
14mm bolt heads
^ Vehicle is involved in SSC 50J. See SSC 50J instructions and replace the ball joint. Please note previous instructions for 50J should be replaced with revised ones available from TIS which reflect that 17 mm bolt heads fall under 70B.
17mm bolt heads
^ The vehicle is involved in SSC 70B.
^ Proceed to "A. REPLACE THE FRONT SUSPENSION LOWER BALL JOINTS"
PARTS KIT CONTENTS
REFERENCE FOR EARLY 2004 MODEL YEAR TUNDRA VEHICLES
^ Please note that all 2004 Model Year vehicles require Ball Joint Replacement either under SSC 70B or SSC 50J. However, you may encounter some early 2004 vehicles with either the 70B or 50J ball joint.
^ The following procedure will help you identify which campaign the early 2004 Model Year vehicle falls under.
1) Confirm the size of the "Front Suspension Lower Ball Joint Bolt Heads."
a) For vehicles with...
14mm bolt heads
^ Vehicle is involved in SSC 50J. See SSC 50J instructions and replace the ball joint. Please note previous instructions for 50J should be replaced with revised ones available from TIS which reflect that 17 mm bolt heads fall under 70B.
17mm bolt heads
^ The vehicle is involved in SSC 70B.
^ Proceed to "A. REPLACE THE FRONT SUSPENSION LOWER BALL JOINTS"
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.