Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONWHEELS AND TIRESTIRE MONITORING SYSTEMTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURES
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Scan Tool Testing and Procedures
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Scan Tool Testing and Procedures
DATA LIST/ACTIVE TEST
1. DATA LIST
a. Connect the intelligent tester to DLC3.
b. Turn the ignition switch to the ON position.
c. Following the display on the intelligent tester, read the "DATA LIST".
1. DATA LIST
a. Connect the intelligent tester to DLC3.
b. Turn the ignition switch to the ON position.
c. Following the display on the intelligent tester, read the "DATA LIST".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.