Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSPRESSURE, VACUUM AND TEMPERATURE SPECIFICATIONSENGINE LUBRICATIONENGINE OIL PRESSURE
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Engine Oil Pressure
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Engine Oil Pressure
Standard Oil Pressure
At Idle 29 kPa (0.3 kgf-cm2, 4.3 psi) or more
At 3,000 RPM 160 to 539 kPa (1.6 to 5.5 kgf-cm2, 23 to 78 psi)
At Idle 29 kPa (0.3 kgf-cm2, 4.3 psi) or more
At 3,000 RPM 160 to 539 kPa (1.6 to 5.5 kgf-cm2, 23 to 78 psi)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.