Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSERVICE PRECAUTIONSCUSTOMER SAFETY INFORMATIONFOR VEHICLES EQUIPPED WITH MOBILE COMMUNICATION SYSTEMS
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
For Vehicles Equipped With Mobile Communication Systems
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION For Vehicles Equipped With Mobile Communication Systems
FOR VEHICLES EQUIPPED WITH MOBILE COMMUNICATION SYSTEMS
a. Install the antenna as far away from the ECU and sensors of the vehicle electronic systems as possible.
b. Install an antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle electronic systems. For details about ECU and sensor locations, refer to the section of the applicable components.
c. Keep the antenna and feeder separate from other wiring as much as possible. This will prevent signals from the communication equipment from affecting vehicle equipment and vice versa.
d. Check that the antenna and feeder are correctly adjusted.
e. Do not install a high-powered mobile communication system.
a. Install the antenna as far away from the ECU and sensors of the vehicle electronic systems as possible.
b. Install an antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle electronic systems. For details about ECU and sensor locations, refer to the section of the applicable components.
c. Keep the antenna and feeder separate from other wiring as much as possible. This will prevent signals from the communication equipment from affecting vehicle equipment and vice versa.
d. Check that the antenna and feeder are correctly adjusted.
e. Do not install a high-powered mobile communication system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.