Programming and Relearning

2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Programming and Relearning
PRECAUTION

NOTE:
- When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name
Power Window Control System

- Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM.

HINT: Initialization cannot be completed by only removing the battery.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.