SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSINSPECTION
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)

Inspection

2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Inspection

ECM:





INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE (-) BATTERY TERMINAL
2. REMOVE GROVE COMPARTMENT
a. Remove the 2 screws and glove compartment door.
b. Remove the 3 screws and lower No.2 finish panel.

3. REMOVE HEATER TO REGISTER DUCT
4. REMOVE ECM
a. Disconnect the 5 connectors.
b. Remove the 2 bolts and ECM.

5. INSPECT ECM
Refer to Control Module Pinout Values. Pinout Values and Diagnostic Parameters
6. REINSTALL ECM
a. Install the ECM with the 2 bolts.
b. Connect the 5 connectors.

7. INSTALL HEATER TO REGISTER DUCT
8. INSTALL GLOVE COMPARTMENT
a. Install the lower No.2 finish panel with 3 screws.
b. Install the glove compartment door with the 2 screws.

9. CONNECT CABLE TO NEGATIVE (-) BATTERY TERMINAL
10. PERFORM INITIALIZATION
a. Perform initialization.

HINT: Some system need initialization when disconnecting the cable from the battery terminal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.