Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Camshaft Position Sensor: Service and Repair
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Service and Repair
Camshaft Position Sensor:
REMOVAL
1. DRAIN ENGINE COOLANT
2. REMOVE DRIVE BELT
3. REMOVE NO. 3 TIMING BELT COVER LH
4. REMOVE CAMSHAFT POSITION SENSOR
Remove the bolt, stud bolt and camshaft position
INSTALLATION
1. INSTALL CAMSHAFT POSITION SENSOR
Install the camshaft position sensor with the bolt stud bolt
Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)
2. INSTALL NO. 3 TIMING BELT COVER LH
3. INSTALL DRIVE BELT
4. FILL ENGINE COOLANT
5. CHECK ENGINE COOLANT FOR LEAKS
6. CHECK IGNITION TIMING
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.