Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION RELAYTESTING AND INSPECTION
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Power Distribution Relay: Testing and Inspection
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Testing and Inspection
ON-VEHICLE INSPECTION
1. REMOVE ACC CUT RELAY
a. Remove the cowl side junction block cover RH.
b. Remove the ACC CUT relay from the cowl side junction relay block RH.
2. INSPECT ACC CUT RELAY
a. Measure the resistance of the ACC CUT relay.
If the result is not as specified, replace the relay.
3. INSTALL ACC CUT RELAY
1. REMOVE ACC CUT RELAY
a. Remove the cowl side junction block cover RH.
b. Remove the ACC CUT relay from the cowl side junction relay block RH.
2. INSPECT ACC CUT RELAY
a. Measure the resistance of the ACC CUT relay.
If the result is not as specified, replace the relay.
3. INSTALL ACC CUT RELAY
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.