Engine Oil Replacement Light Reset

Engine Oil Replacement Reminder Light
This light reminds you when to replace the engine oil.

This light will come on when the ignition switch is turned to "ON", and will go off after about a few seconds.

When you drive for about 7200 km (4500 miles) after engine oil replacement, this light flashes for about 3 seconds and then about 12 seconds with the ignition key is turned to "ON" position. If you continue driving without engine oil replacement, and if the driving range exceeds 8000 km (5000 miles), the light will come on after the ignition key is turned to "ON" position. The light will remain on thereafter.

If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road condition. If the light comes on, replace it as soon as possible.

You need to reset the light after the engine oil replacement. Reset the light by following the procedure below.


1. Turn the ignition key to the "ACC" position or "LOCK" position with the Odometer reading shown.

2. Turn the ignition key to the "ON" position while holding down the trip meter reset button.

Hold down the knob for at least 5 seconds. The Odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing.


Navigation Maintenance Item Data (If equipped)

This system has a function which informs you of the time to replace certain parts or components as well as other information shown on the screen. When the system begins operating after reaching either the information items date or driving distance, the "information" screen will be displayed.

To avoid seeing the "information" screen again, touch the "Do not display this message again" switch.

Setting Maintenance Information

1. Push the "INFO" button to display the "Information Menu" screen, and then touch the "Maintenance" switch.

2. Touch your desired icon and input the conditions.

Date: Input the next maintenance date.

Distance: Input the driving distance until the next maintenance check. You can input up to five digits for the driving distance.

When you touch the "Personal Event" switch on the "Maintenance" screen, the screen changes to the "Personal Event" screen. Touch the keys to input your desired name and then input the conditions.


After you input the information, touch the "OK" switch. The screen returns to the "Maintenance" screen. The icon color will change to green after the date and driving distance are input. The icon color will change to orange when your vehicle needs to be serviced. The following switches appear on the "Maintenance" screen.

1. Delete all: Cancel all conditions which have been input.

2. Reset all: Reset all items which satisfy either condition.

Touch the "OFF" switch on the "Maintenance" screen, and the "Information" screen will no longer be displayed.

Note:

- For scheduled maintenance information, please refer to the Scheduled maintenance guide or Owners manual supplement.

- Depending on your driving or the road conditions, the system may have a time-lag between the data which has been input and the actual date and driving distance.