Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSTRUNK LAMPTESTING AND INSPECTION
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Trunk Lamp: Testing and Inspection
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Testing and Inspection
INSPECTION
1. INSPECT LUGGAGE ROOM LIGHT SWITCH
a. Disconnect the connector from the interior light assembly.
b. Turn the interior light switch ON, check that continuity exists between terminal 2 and body ground.
If continuity is not as specified, replace the light assembly or bulb.
c. Turn the interior light switch to DOOR, check that continuity exists between terminals 1 and 2.
If continuity is not as specified, replace the light assembly or bulb.
1. INSPECT LUGGAGE ROOM LIGHT SWITCH
a. Disconnect the connector from the interior light assembly.
b. Turn the interior light switch ON, check that continuity exists between terminal 2 and body ground.
If continuity is not as specified, replace the light assembly or bulb.
c. Turn the interior light switch to DOOR, check that continuity exists between terminals 1 and 2.
If continuity is not as specified, replace the light assembly or bulb.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.