Active Test

2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Active Test
PERFORM ACTIVE TEST

HINT: Performing the ACTIVE TEST using the intelligent tester allows the relay, VSV, actuator and so on to operate without part removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten labor time.




a. Connect the intelligent tester to the DLC3.
b. Turn the ignition switch to the ON position.
c. From the display on the tester, perform the "ACTIVE TEST".
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.