Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISCRUISE CONTROLDIAGRAMSDIAGNOSTIC AIDSHOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMSELECTRONIC CIRCUIT INSPECTION PROCEDURECHECK FOR OPEN CIRCUIT
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Check For Open Circuit
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Check For Open Circuit
CHECK FOR OPEN CIRCUIT
a. For an open circuit in the wire harness in Fig. 1, check the resistance or voltage, as described.
b. Check the resistance.
1. Disconnect connectors A and C and measure the resistance between them.
HINT: Measure the resistance while lightly shaking the wire harness vertically and horizontally. If the results match the examples, an open circuit exists between terminal 1 of connector A and terminal 1 of connector C.
2. Disconnect connector B and measure the resistance between the connectors.
If the results match the examples, an open circuit exists between terminal 1 of connector B2 and terminal 1 of connector C.
c. Check the voltage.
1. In a circuit in which voltage is applied to the ECU connector terminal, an open circuit can be checked by conducting a voltage check.With each connector still connected, measure the voltage between the body ground and these terminals (in this order): 1) terminal 1 of connector A, 2) terminal 1 of connector B, and 3) terminal 1 of connector C.
If the results match the examples, an open circuit exists in the wire harness between terminal 1 of connector B and terminal 1 of connector C.
a. For an open circuit in the wire harness in Fig. 1, check the resistance or voltage, as described.
b. Check the resistance.
1. Disconnect connectors A and C and measure the resistance between them.
HINT: Measure the resistance while lightly shaking the wire harness vertically and horizontally. If the results match the examples, an open circuit exists between terminal 1 of connector A and terminal 1 of connector C.
2. Disconnect connector B and measure the resistance between the connectors.
If the results match the examples, an open circuit exists between terminal 1 of connector B2 and terminal 1 of connector C.
c. Check the voltage.
1. In a circuit in which voltage is applied to the ECU connector terminal, an open circuit can be checked by conducting a voltage check.With each connector still connected, measure the voltage between the body ground and these terminals (in this order): 1) terminal 1 of connector A, 2) terminal 1 of connector B, and 3) terminal 1 of connector C.
If the results match the examples, an open circuit exists in the wire harness between terminal 1 of connector B and terminal 1 of connector C.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.