Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSDTC 44VEHICLE STABILITY CONTROL SYSTEM
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Vehicle Stability Control System
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Vehicle Stability Control System
DTC C1244/44 Open or Short in Deceleration Sensor Circuit
DESCRIPTION
The skid control ECU receives signals from the yaw rate sensor (deceleration sensor) via the CAN2 communication system.
The yaw rate sensor has a built-in deceleration sensor.
This sensor detects deceleration on the vehicle. The sensor signal is used in ABS and BA and TRAC and VSC control.
INSPECTION PROCEDURE
NOTE: When replacing the yaw rate (deceleration) sensor, perform the zero point calibration. Calibration
DESCRIPTION
DTC Detecting Condition:
The skid control ECU receives signals from the yaw rate sensor (deceleration sensor) via the CAN2 communication system.
The yaw rate sensor has a built-in deceleration sensor.
This sensor detects deceleration on the vehicle. The sensor signal is used in ABS and BA and TRAC and VSC control.
Wiring Diagram:
Step 1-2:
Step 3-4:
INSPECTION PROCEDURE
NOTE: When replacing the yaw rate (deceleration) sensor, perform the zero point calibration. Calibration
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.