SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSDTC 41VEHICLE STABILITY CONTROL SYSTEM
2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)

Vehicle Stability Control System

2006 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Vehicle Stability Control System
DTC C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage

DESCRIPTION

DTC Detecting Condition:




If there is a problem with the skid control ECU power supply circuit, the skid control ECU outputs DTC and prohibits operation under the fail safe function.

Wiring Diagram:






Step 1:




Step 1(continued)-4:




INSPECTION PROCEDURE

NOTE: When replacing the skid control ECU, perform zero point calibration. Calibration
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.