Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20064RUNNER SR5, 4.7 T, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEMECM (1GR-FE)REPLACEMENT
2006 Toyota 4Runner SR5, 4.7 T, AWD
ECM (1GR-FE): Replacement
2006 Toyota 4Runner SR5, 4.7 T, AWDSECTION Replacement
- REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.2
- REMOVE GLOVE COMPARTMENT DOOR SUB-ASSY
- REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2
- REMOVE ECM
- Disconnect the 5 the ECM connectors from the ECM.
- Remove the 3 nuts and the ECM.
- Remove the 2 screws and the ECM bracket No. 1 from the ECM.
- Remove the 2 screws and the ECM bracket No. 2 from the ECM.
- INSTALL ECM
- Install the ECM bracket No. 2 with the 2 screws to the ECM.
- Install the ECM bracket No. 1 with the 2 screws to the ECM.
- Install the ECM with the 3 nuts.
Torque: 13 N.m (133 kgf.cm, 10 ft.lbf)
- Connect the 5 ECM connectors to the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.