Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005TACOMA 4WD L4-2.7L (2TR-FE)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSTESTING AND INSPECTIONINITIAL INSPECTION AND DIAGNOSTIC OVERVIEWINITIAL INSPECTIONINSPECTION
2005 Toyota Tacoma 4WD L4-2.7L (2TR-FE)
Inspection
2005 Toyota Tacoma 4WD L4-2.7L (2TR-FE)SECTION Inspection
INSPECTION
1. INSPECT AIR BAG CUT OFF SW CYLINDER SUB-ASSEMBLY
a. Check the resistance.
1. Using an ohmmeter, measure the resistance between the terminals.
If the result is not as specified, replace the air bag cut off sw cylinder sub-assembly.
2. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a. Check the switch illumination.
1. Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 12.
2. Check that the passenger airbag ON indicator light up.
If the operation is not as specified, replace the hazard warning signal switch assembly.
3. Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 5.
4. Check that the passenger airbag OFF indicator light up.
If the operation is not as specified, replace the hazard warning signal switch assembly.
1. INSPECT AIR BAG CUT OFF SW CYLINDER SUB-ASSEMBLY
a. Check the resistance.
1. Using an ohmmeter, measure the resistance between the terminals.
If the result is not as specified, replace the air bag cut off sw cylinder sub-assembly.
2. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
a. Check the switch illumination.
1. Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 12.
2. Check that the passenger airbag ON indicator light up.
If the operation is not as specified, replace the hazard warning signal switch assembly.
3. Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to terminal 5.
4. Check that the passenger airbag OFF indicator light up.
If the operation is not as specified, replace the hazard warning signal switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.